Victor Reader Trek Install new map packages HERE maps

Install the new HERE maps

When your VR Trek is updated to version 2.1; Install the new HERE maps, directly from your device or manually for a faster installation by following this procedure:

Step 1. Download the map package you need from the below links by following these steps:

Via SD card reader: place your VR Trek’s SD card into your computer’s SD card slot and transfer the downloaded package file to the root of the SD Card. Place the card in the VR Trek and go to Step 2.
Via USB: If you do not have an SD card reader, power off your VR Trek and connect it to the USB port of your computer. After it vibrates once, press the power ON button and wait until you hear “Device Connected”. Your computer will now be reading the Trek’s SD card and you can transfer the downloaded package file to the card. Use the computer to eject the drive then disconnect the VR Trek from the USB port. Move on to Step 2.

Step 2. With your device powered ON and the Online Bookshelf setting “automatic check for updates” is ON, go to Orientation mode then the system will announce “Maps were found on the SD Card” and you will prompted to install them. Press confirm to begin installation.

Step 3. You will be asked if you wish to keep the maps on the SD card after installation. This can be useful if you eventually need to change regions, for example if you need to switch from North America to Europe for a trip at a later date.

Step 4. The new maps will be installed, and the system will shut down.

Step 5. The next time you power on the device you will have access to the new map package.

Note: While you are installing the free maps, HumanWare invites you to subscribe to the Trek GPS newsletter at http://www.humanware.com/GPSnews